Leaf Blower Carburetor Cleaning Instructions

Leaf Blower Carburetor Cleaning Instructions

A carburetor boosts the performance of a leaf blower. It ensures the ratio of fuel and air is accurate in order for the engine to operate. A carburetor has to be maintained in good condition for it to perform its functions as desired. Cleaning is an effective carburetor maintenance practice. Cleaning a carburetor has to be done systematically as will be shown in this article.

Accurately Remove the Carburetor From the Leaf Blower​

Before commencing the cleaning process, the carburetor has to be detached from the leaf blower. The process of removing it is governed by steps have to be carefully followed. Understanding each step is important so that the carburetor can be reassembled correctly once cleaning is finalized. The process entails a number of steps as outline below:​

  • Empty the fuel tank by pouring the fuel into a suitable container.
  • Disengage the spark plug wire from the leaf blower to avoid any form of harm.
  • Dismount the screws on the air filter cover to safely remove it.
  • Dismount the screws mounted on the carburetor to safely remove it.
  • Remove the air box and detach it from the carburetor throttle and choke levers.
  • Lastly, the fuel lines have to be detached from the carburetor to entirely remove it from the leaf blower.

Clean the Carburetor and Give It Time to Dry

After successfully removing a carburetor from the leaf blower, cleaning follows. An aerosol carburetor cleaner should be used to clean the carburetor. All the ports and jets located on the carburetor have to be thoroughly cleaned. Cleaning has to be done for several minutes to get good results. Afterwards, the carburetor should be allowed enough time to dry. Drying is done using a clean rag. This should take not less than 10 minutes. It is crucial to dry the carburetor well to avoid damage to its diaphragms. The damage is likely to occur depending on the carburetor cleaner used. The damage occurs if the carburetor is reconstructed before it completely dries out. Compressed air is also used in cleaning a carburetor. It is used to remove the cleaner that remains on a carburetor.

Reconstruct the Carburetor

Once satisfied with the cleaning process, reconstruct the carburetor before reinstalling it. All the components of the carburetor have to be installed at the specific place they were removed. For example, the needle and level have to be fixed using screws on the bottom part of the carburetor.​

Reinstall the Carburetor​

This is the final step after cleaning the carburetor. The carburetor should be integrated into the leaf blower. This involves a reverse of the steps mentioned in step 1. They include:​

  • Attach the fuel lines properly on the carburetor.
  • Put the carburetor properly back into the air box.
  • Place the carburetor at its exact location on the engine and mount screws to properly hold it.
  • Reinstall the spark plug wire.

Finally, a carburetor is like the heart of a leaf blower. It ignites life into a leaf blower by ensuring the mixture of air and fuel is correct. In regard to this, it has to be cleaned frequently following cleaning instructions as explained in this article.

Popular posts